QUESTION 201
Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the CRC value?
A. VTP
B. 802.1Q
C. DTP
D. ISL
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (201-210)
Articles Tagged with 642-813 exam
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (191-200)
QUESTION 191
What is a characteristic of a VLAN map that does not contain a match clause?
A. implicit deny feature at end of list
B. implicit forward feature at end of list
C. can only be implemented by the input direction within the VLAN
D. can only be implemented by the output direction within the VLAN
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (181-190)
QUESTION 181
When a VLAN port configured as a trunk receives an untagged frame, what will happen?
A. The frame will be dropped.
B. The frame will cause an error message to be sent.
C. The frame will be processed as a native VLAN frame
D. The frame will first be tagged, then processed as a native VLAN frame.
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (141-150)
QUESTION 141
You have a VLAN implementation that requires inter-vlan routing using layer 3 swithches. Drag the steps on the left that should be part of a VLAN-based verification plan to the spaces on the right. Not all choices will be used. 
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (131-140)
QUESTION 131
Refer to the exhibit. Which two statements are true about the output from the "show standby vlan 50" command? (Choose two) 
A. Catalyst_A is load sharing traffic in VLAN 50.
B. Hosts using the default gateway address of 192.168.1.2 will have their traffic sent to Catalyst_A.
C. The command standby 1 preempt was added to Catalyst_A.
D. Hosts using the default gateway address of 192.168.1.1 will have their traffic sent to 192.168.1.11 even after Catalyst_A becomes available again.
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (121-130)
QUESTION 121
Refer to the exhibit. Which statement is true about the output? 
A. The port on switch CAT1 is forwarding and sending BPDUs correctly.
B. The port on switch CAT1 is blocking and sending BPDUs correctly.
C. The port on switch CAT2 is forwarding and receiving BPDUs correctly.
D. The port on switch CAT2 is blocking and sending BPDUs correctly.
E. The port on switch CAT3 is forwarding and receiving BPDUs correctly.
F. The port on switch CAT3 is forwarding, sending, and receiving BPDUs correctly.
Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (91-100)
QUESTION 91
Which statement correctly describes enabling BPDU guard on an access port that is also enabled for PortFast?
A. Upon startup, the port transmits 10 BPDUs. If the port receives a BPDU, PortFast and BPDU guard are disabled on that port and it assumes normal STP operation.
B. The access port ignores any received BPDU.
C. If the port receives a BPDU, it is placed into the error-disable state.
D. BPDU guard is configured only globally and the BPDU filter is required for port-level configuration.